Motec GPS-BL1 Manuel d'utilisateur télécharger pdf (Page 4)

2 Using the GPS

Antenna Connection

Insert the antenna connector until it clicks into place - check by ensuring the

connector cannot be pulled out easily.

Be careful not to damage the antenna cable when routing it through the

vehicle and ensure that the cable cannot be squashed or otherwise damaged

during use.

GPS Unit Electrical Connections

The GPS unit sends data to the logging device via an RS232 serial

connection.

The wiring between the GPS unit and the logging device should be as short

as possible, preferably less than 1m (3ft)

The following table shows how to wire the GPS unit to a number of Motec

logging devices using the supplied adapter cable.

GPS

Adapte

r Pin

GPS

Name

Logging

Device

Name

ADL2 SDL ACL

Bat - Bat - 7 4 1

TX RX 79 34 15

Bat+ Bat+ 8 3 2

Note that while the unit has a 5V to 18V power supply range the unit draws

too much current to be powered from the 5V supply on the logging device so

it must be powered from the battery supply.

Note that the ADL2 and SDL logging devices only have one serial connection

therefore if an ECU is to be connected then it must be connected via CAN

(Note that not all ECUs have a CAN connection)

GPS Configuration

The GPS comes preconfigured from Motec to suit Motec logging equipment.

1 2 3 4 5 6 7 8

Pas de commentaire

Motec GPS-BL1 Manuel d'utilisateur Page 4